Hi Mike,
I have a problem with the Control Cue - HTTP request.
I control the one hand, AXIS 214PTZ camera to go to different positions, then I control my projector via HTTP request.
Now it is so, Showcue freezes for an HTTP Request a to the camera for a moment and thus be simultaneously launched Audiocues delayed, although the command to the camera comes on and this also moves to the new location, Showcue reports but nevertheless an error in the status bar. Send Failure # 1
Second, if the projector on the network is down, freezes Showcue for at least 10 seconds, WHILE trying to send it well the command and responds again until it gives up the command to be rid of.
Showcue therefore always seem to expect a response from the remote station. Nice, but often also a hindrance if other cues be delayed thereby.
Would it be possible, to give the HTTP Request an option, for example, "Send blind" as to permit the UDP protocol?
thank you