Show Cue System

Hi Mike. Opened my 11.3.8 cue file and saved to a new version.

Keen to get going with callable cues!! Created two callable control send cues, each with just one control change send. Created a manual test cue to call one of these callable cues. Exited editor and started the test cue. Message sent fine but in the bottom cue panel the cue is shown as playing. Pressing escape doesn't stop it. If I run an audio cue and then press escape then all cues stop and I can repeat the test.


Cheers

Richard

Incidently it is still "playing" in that I can't reselect the calling cue as my next manual cue and rerun it until I have forced it to stop by running and audio cue and stopping all.

Fix ready for 11.4.0 RC3

Thanks Mike. Will RC3 be available soon? I'm working on a new show for next weekend and need to make a decision which way to go . . . .

Thanks

Richard

I should be able to upload RC3 tomorrow (Monday).

Great Mike. Look forward to it!!