Default Devices and Levels setting in 9.5.0
Posted: Fri Jan 18, 2008 3:35 am
I think I have identified a bug in SCS 9.5.0 regarding the "Default Devices and Levels for New Audio File Cues" setting in Production Properties. With a new file for me this defaults to Device 1 as FOH with Level -3.0dB, the remaining devices being blank at -96.0dB.
In a show I was creating today I realised that in some of the cues (but not all) the blank devices were showing at level 0.0dB. To correct this, in each affected cue I selected FOH for each device, dragged the slider back to -96.0dB and deselected again. This condition then stuck for the rest of the session. However, after saving and closing then re-opening, ALL the cues reverted to the unused devices showing at level 0.0dB whilst the Production Properties show -96.0dB.
I don't recall noticing this in 9.4.6.
Malcolm
In a show I was creating today I realised that in some of the cues (but not all) the blank devices were showing at level 0.0dB. To correct this, in each affected cue I selected FOH for each device, dragged the slider back to -96.0dB and deselected again. This condition then stuck for the rest of the session. However, after saving and closing then re-opening, ALL the cues reverted to the unused devices showing at level 0.0dB whilst the Production Properties show -96.0dB.
I don't recall noticing this in 9.4.6.
Malcolm