[Resolved] TELNET control failure
Posted: Thu Jan 17, 2013 1:36 pm
I've used SCS several times to control Light Factory, running on the same machine. But tonight, it fails to send control signal.
I'm running off my laptop, in the theatre, so I'm looking for some pretty quick help.
The control messages are exactly of the same form as I've always done. Eg,
Cue "RG" 0 GO
"RG" is the name of the cuelist in Light Factory.
When I test the cue, SCS just says "failed to send #1".
I must have some setting cross-threaded. I've attached a screen shot of Production Properties/Control Send Devices.
Any help is greatly appreciated. Thanks
Chuck Puckett
"I don't want to steal the show. I only want to borrow it for a while"
I'm running off my laptop, in the theatre, so I'm looking for some pretty quick help.
The control messages are exactly of the same form as I've always done. Eg,
Cue "RG" 0 GO
"RG" is the name of the cuelist in Light Factory.
When I test the cue, SCS just says "failed to send #1".
I must have some setting cross-threaded. I've attached a screen shot of Production Properties/Control Send Devices.
Any help is greatly appreciated. Thanks
Chuck Puckett
"I don't want to steal the show. I only want to borrow it for a while"