[Fix 11.3.0] Loop count error in SCS 11.3rc 2 and 3

[hitnekey]

Hi Mike,

Just thought you might like to be aware of a very minor glitch in recent release candidates.

I have a small audio file (.wav) - about 7 seconds long. I have looped the middle 6 seconds approx of this file and set #loop count of 14.

In earlier versions of SCS, the loop counter increments at the start of the loop until reaching the figure set in #loop where it then exits the loop. But in my test on the latest release candidates, the loop counter increments at both the beginning and end of the loop, so exiting the loop quicker than expected.

This happens in both SCS11.3 rc2 and rc3.

SCS 11.2.5 runs fine as does SCS11.3 rc 1

I've emailed you a cut down cue file showing this glitch.

Thanks

Peter

[Mike Daniell]

Fix ready for RC4.