Wierd Problem.
Posted: Mon Jan 29, 2007 12:13 pm
Today, I updated the software to 9.3.1 (9.3.2 was not released yet). When I got to the theater to write cues, after a little bit of work Windows gave me the "SCS has encountered an error and needs to close" dialog. This happened a couple of times.
Also, I have three devices defined in the production properties, one stereo and two mono. I would play the cue list with the stereo pair and one of the mono speakers (not used in the same cue) with no problems. Then I would get to the one cue where the other mono speaker is used. I would play the cue, but no sound would come out. I would restart the program, and I would jump to that cue and it would play just fine. Then I would start at the top of the show and the problem woud repeat. Once, none of the speaker outputs would have sound coming from them.
P.S. I have a Creative SB card with the correct settings enabled.
~Jeff
Also, I have three devices defined in the production properties, one stereo and two mono. I would play the cue list with the stereo pair and one of the mono speakers (not used in the same cue) with no problems. Then I would get to the one cue where the other mono speaker is used. I would play the cue, but no sound would come out. I would restart the program, and I would jump to that cue and it would play just fine. Then I would start at the top of the show and the problem woud repeat. Once, none of the speaker outputs would have sound coming from them.
P.S. I have a Creative SB card with the correct settings enabled.
~Jeff