Show Cue System

I'm running 9.2.5 on a Dell laptop with Windows XP.

When trying to add a subcue the program exited and gave me the following error:

Instruction at "0x08124059" referenced memory at "0x08714be0". The memory could not be "read".

Click OK to terminate the program
Click Cancel to debug

I had 4 cues in the system and one cue that refereced an incorrect filename that I had just deleted.

Program restarted fine. The deleted cue wasa back and the subcue was not there but everything else was.

After restarting SCS and trying again, do you get the same error?

No. I removed the faulty cues that were trying to find a non-existent file and that problem went away.

I have a new one, it is a new thread.