Hi
i'm using the x32 as sound interface with the show cue system. the signal for the scs go to the x32 very loud. the gain input is close but it"s still loud. do you know that problem?
thank you
roei
x32 with scs as sound interface
Re: x32 with scs as sound interface
Hi,
this is normal when using digital interfaces. SCS's 0dB level means 0dBFS which is 12 dB more than the normal "studio" level +4dBu.
If there's a digital trim within the X32 set it to -12dB. Or You can use the trim parameter in the SCS device manager.
HTH Jörg
this is normal when using digital interfaces. SCS's 0dB level means 0dBFS which is 12 dB more than the normal "studio" level +4dBu.
If there's a digital trim within the X32 set it to -12dB. Or You can use the trim parameter in the SCS device manager.
HTH Jörg
