Dear All,
I'm about to purchase an Echo Audiofire 8 interface and a cardbus firewire 400 adaptor to use with SCS running on a laptop, which has a type 2 cardbus slot (ie 32bit). Any advise please on these two areas:
I know that some multi-output interfaces don't offer all their outputs to DirectX, and thus to SCS. Does the Audiofire driver allow SCS to use all its outputs?
Echo recommend a firewire port using a Texas Instruments chipset, and I ideally want one with a six-pin not four-pin connector, so I can power the interface from the bus. Anyone know which models of cardbus firewire adaptor would be suitable?
Anyone using a similar setup with SCS, with good or bad opinions of it?
Many thanks in advance
Tom
Audiofire 8 interface with cardbus firewire adaptor
-
TomLishman
- Posts: 1
- Joined: Sun Apr 06, 2008 9:55 pm