Show Cue System

Hi Candy

Ja doch. Tut es auch jemand aus Speyer?

Using lighting cue, I faded in a couple of fixtures. At a specific time, when the fading procedure is still running, I start another lighting cue to switch on a fixture which is not involved in the fading ones. This switch causes an immediate stop of the fading process. Regardless if it's done as a ...

Resolved: Thank you so much Mike for getting that device running, meaning all 8 channels could be seen and used. After a small change in SCS ( SCS11.8.4aa), the following points could be found out: > The device has to be configured as a 7.1 device in the Windows Control Panel <Sound> setup. > This ...

I have the same problem with a similar cheap 7.1 USB external box CSL - USB 7.1 Soundkarte extern 8-Kanal - Channel USB Soundbox https://www.amazon.de/CSL-Soundkarte-Lautsprecher-gleichzeitige-Audioger%C3%A4te/dp/B00KXAVBQY/ref=pd_sbs_23_1/260-3539599-0293659?_encoding=UTF8&pd_rd_i=B00KXAVBQY&pd_rd_...

Thank you Mike for your very quick help. With the release Candidate 2 the Enttec DMXUSBPro MK2 will be indentified as FT245R USB FIFO followed by the serial number in brackets. The dropdown for the DMX port is displayed as it should!. The DMX signals go to the correct ports and lights. But... in a s...

I run SCS11.8.1 with an Enttec DMXUSBPro (Firmware 1.44) using the FTDI-Drivers vers. 2.12.28 at ComPort 3 and it worked really good. In SCS / Physical device it shows up as DMXUSBPro with it's Serial Number in brackets Today I got a new Enttec DMXUSBPro MK2 (Firmware 4.15). After installation it ha...