Show Cue System

Thanks Dee,

I don't have one because I don't use QLab but I'll have a chat with one of the guys I'm working with who does.

Phil.

Thanks Dee,

Might be worth a try.

Phil.

I'm sure you've looked at this before Mike but is there anyway that SCS can support QLab files, either export or import them from a memory stick or preferable a shared drive like OneDrive. (Although OneDrive is not too good on a Mac.) I occasionally end up by colaborating on a production with someon...

Thanks Didi, Yes unfortunatly it is a bit late as we only had limited time. But it is also interesting that you used /cs/...... that's what we used but it never worked despiute the desk showing it actually received it. We eventually put it down maybe we should have sent /EOS/....... But at the same ...

Ondřej, [UPDATED] Use a DAW like say Reaper (others are available) to split each chanel into it's individual track creating a file for each chanel L&R. Then in SCS send each side to a different mono output from SCS. You can then use your NonoKontrol to adjust the volume of each mono chanel relative ...

I get something similar (a crackling rather than a hum) with my laptop when plugged into docking station which also provided power. Works fine either not on the docking station or if not plugged in to power at all. AND it's not an SCS problem as it accects other audio as well.

Bob Marley,

Did you ever solve this?

See my post above - we seem to be able to send the messages over and we can see them in the log, but they don't actually get acted upon. Woder if you solved it?

Phil.

Anybody had any luck sending messages to an ETC lighting desk? We've had some success - SO most of the time we can send the OSC messages over ethernet and they are rec eived and displayed by the lighting desk. But they doesn seem to get acted upon. So I was using similar to the following: /cs/playba...

Yep - I can see that Heiko

Was worth a thouyght though.

Heiko, As a workaround would a Note Cue displayed on a 2nd screen and triggered by a Cue Marker do it for you? You could attach a 2nd HDMI screen to the PC and run it over ethernet to the stage. Then have a series of Note Cues - Eg GO Swans (My knowledge of Ballet is very limited) displayed for say ...

Most digital mixers these days will act as a USB interface and come with FX processors built in. So in a lot of respects the worlds your oyster. Before I go to a venue I usually check if and what they have and will aim to use their mixer if I can. Otherwise, personally I use a Berhinger X18 - it has...

That would work Mike.

I already use Fade in and Fade Out times on Callable cues

As always thanks for your responsiveness.

So in the past I've had a couple of shows where we have a longish piece of music that the cast moving to or perhaps backinbg music a fight type scene. In rehearsals we've wanted to keep going back to the particular point in the piece to rehearse and refine the associated movenments. The current prod...

Thanks Mike,

Log file sent to Support@......

Phil.

Mike, Trying to set up a skeleton file for a future production USING 11.10.06 BETA 3 I get the following SCS Sanity Check message Incorrect sCue for Sub Q170 \sCue=Q170, sCue=C000 Clicking OK wonn't then let me save due to sanity check. Deleting cue C000 allowed me to save and close If you can remin...